Quote:
Originally Posted by Nickco43
How did you install the camera in the handle? Did you just epoxy the camera into the handle?
|
U need to remove the plastic cover around the oem camera, then use a drill bit to open a little over 18mm on that Chinese camera hole. Then put silicone all around and press it. When it dries it look so damn good. and put the silicone cover around to hide the imperfections. Thats it!
I will never going to cut my trunk for the camera. It is just me. I like oem application but also like to keep it oem
But it looks pretty good if you can cut it right for the FX handle.
Here is how it looks like :
And this is the differences between Chinese handle Vs F10 m5 handle :