Quote:
Originally Posted by frozenfire
I tried a few times. I checked the conections a few times too. Do you know what cable the speed sensor is on? I could try taking a multimeter and seeing if it is hooked up. I dont want to be checking each indivual cable to see if all them are connected properly...
I also snaped some pics of what it looks like just now (using map 0). Those are the two things that it does, either:
1) nothing and stays with the --- mph (picture 1)
or
2) gives me a "cruise control malfunction" warning on my idrive and displays that on the gauges then (picture 2)
sorry for the crappy pictures, they were taken on my iphone at the speed shown below -_-'
|
I'm not sure which specific pin it is. Since you said you have a multi-meter, it shouldn't take too long to run a continuity test on each pin in the harness (keep in mind there are some wires in the harness that aren't used). It may be quicker though to get in contact with Vishnu. I am past the guessing phase at this point. Hope you get it all works out though.