Thank you for your help.
All great ideas. I will check the pins on the DME.
Yes, codes are reset after every change.
There are some PERMANENT codes. I can't get rid of those. Is that the problem? They don't show up the regular way or in ISTA but do show with a regular scanner as PERMANENT codes.
Quote:
Originally Posted by technician117
Have you tried checking the connections on the DME for that bank? I'd unplug each one, inspect the pins on both sides and then make sure they get fully seated when reconnecting.
Are you clearing codes each time you swap parts around? I would, just in case you see something different.
|