12-24-2012, 09:54 PM
|
#48
|
Major General
Drives: '08 E90 335i, '99 E36 M3
Join Date: Apr 2009
Location: Houston, TX & Atlanta, GA
|
Quote:
Originally Posted by Ænema
Basically, you log "Boost setpoint factor" and "MAF req(WGDC)" and then adjust the WGDC base table in the corresponding cells where the overshoots/undershoots occur. For over boosting i like to make adjustments(reductions) by a factor of 5-10%. For under boosts I go by a smaller value(2-5%) because as you increase the value the percentage increase grows each time. Increasing the WGDC adder table also works on under boost, but I kind of like using the base table.
My stock turbos are pretty healthy and not very picky so I haven't had to make a lot of changes. I have a set of TD04s on the way, when they get installed I have a felling I'm going to be spending a lot time in the WGDC tables haha
|
Good info, thanks!
|
|
|