[doughboy]

Hi, thanks for that.

Ah OK, so there is no supply at airbag 1&3 ? I thought from David's posts that the supply was ready to use there.

Yes I realise I have to add connections to position 1&3 of the airbag connector plug body (wheel side) as in the picture in post 25.

I've had the airbag off a while back to check and have bought the female connectors to go in the airbag socket 1&3 with flying leads and a female plug housing to connect directly to the heater controller module.

The lead set I have made up is shown in post 23 above to get 12v to heater control model.

Now I need a supply to the back of the clock spring unit....

I can't find circuit diagram for a 2016 m6 gc anywhere. I've got rehingold soft ware which I hoped would have diagrams but it doesn't...