OK, I whipped up this diagram real quik like (obviously it is Not To Scale)...
- Lettering is 7/8" (22mm) up from bottom edge of trunk lid all along
- Spacing between the numbers is 1/4" (6.4mm)
- Spacing between numbers and letter (if any) is 7/16" (11mm)
>> 1st draw a reference line parallel to the trunk edge and 7/8"
(22mm) up like my phantom line shown
>> If you were to lay a ruler on that line, align the 2"
(51mm) mark with intersection of that line and trunk edge - the bottom of the badge letter would start there.
>> You could then work backwards using the spacing between letters/numbers as shown (the 7-7/8"
(200mm) dimension is really a reference dim, as that is where my particular lettering ended up - depending on your lettering this distance may be different)
The 7-3/4"
(197mm) dimension from the centerline of the trunk roundel to the begining forward edge of the '3' is also a reference dim - but you can use these reference dims as a roundabout for your install
Hope this helps ya out
