Quote:
Originally Posted by diamondbacvenomx
Hey guys hopefully someone can help me out.
I lost the 3 wires that need to be removed when you install the DPfix in the JB4 PNP. I contacted BMS to buy additional jumper cables to replace the 3 I lost and instead of selling me cables, they suggested I find a few open positions on the factory harness that has no wires and move the corresponding wire over to the JB4 (very cool of them help me find a free solution instead of selling me a product).
Now I can do my own routine maintenance and installed the JB4 myself but I am no where near confident enough to discover these open positions on the factory harness. Maybe I'm making this out to be more complicated than it is but could someone explain a bit further where I can find these open positions? Pictures would be extremely appreciated  |
It will be obvious when you open the ECU. Not all the openings in the stock harness have wires going into them. It varies car to car but what BMS was saying is that the corresponding JB4 harness wires to the stock ones where there is no wire can be removed and swapped into the needed position.
There should be 10+ blank slots for you to choose from.
Mike