|
a. Remove the part number sticker from the bottom of the knob.
b. Undo the five clips (1) at the bottom side to remove the bottom bracket.
c. Use a narrow plier to remove the rubber cap (2) to expose the torx screw (3) holding the iDrive knob.
d. DO NOT mess with the four torx screws (marked in green X) as it will ruin the spacing between the magnets that control the movements of the iDrive knob.
e. Undo four torx screws (4) holding the iDrive buttons panel.
f. Use a flat head screw driver to lift the ribbon cable holder (5) to remove one end of the ribbon cable.
g. Remove the torx screw (3) holding the iDrive knob. Lift the iDrive knob from the top.
h. Undo tab (6) from both sides to release the iDrive button panel.
Now you are free to swap the switches and knobs between different EVO iDrive knobs.
Assemble in reverse order. Make sure the ribbon cable attached to the iDrive knob is channel through the slot (7) to the bottom of the assembly before putting the knob back in position.
|