|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Advice on nettodat coding
|
|
01-06-2015, 02:08 PM | #1 |
Colonel
163
Rep 2,399
Posts |
Advice on nettodat coding
I thought i had cracked how to nettodat code till i ran into some confusions
I am trying to code my CTM module on E93 to close roof while driving.. Steps i done: Read CTM module in NCS. Opened NCS Dummy Select Chassis Select Module. CTM_E93.C03 etc Load Nettodata trc Module data came up Added my custom value in the field GESCHWINDIGKEIT Export Nettodata.man THEN - I am following a few DIY's which said i either needed to re open NCS. load profile NCS Dummy Profile Which i dont have. See pic below: Then i read CN555IC instructions on thread http://www.e90post.com/forums/showthread.php?t=781739 post 7 that i need to 'hit basic functions' (where is basic functions)? I then went to change job in NCS to see if i have CoapiCodeSgNettodat which i dont. see pics below of what jobs i can use: After ive exported nettodata man file what do i do next in my NCS expert to code the car as online i do not have these functions in my NCS? |
01-07-2015, 02:54 AM | #3 |
Colonel
163
Rep 2,399
Posts |
|
Appreciate
0
|
01-07-2015, 08:52 AM | #4 |
Banned
525
Rep 1,527
Posts |
|
Appreciate
0
|
01-07-2015, 02:34 PM | #5 |
Major
188
Rep 1,247
Posts |
Search for the PDF that details how to increase angel eye brightness; it's detailed in there.
A point to note; if you complete any standard coding of the module after nettodat; the nettodat is reverted to stock and will need to be re-run. |
Appreciate
0
|
01-07-2015, 02:38 PM | #6 | |
Colonel
163
Rep 2,399
Posts |
Quote:
wow thats shite didnt know that! |
|
Appreciate
0
|
01-07-2015, 05:41 PM | #7 | ||
Banned
525
Rep 1,527
Posts |
Quote:
|
||
Appreciate
0
|
Bookmarks |
|
|